H3C Technologies H3C SecBlade NetStream Cards - Manual (Page 175)

160
To do… Use the command… Remarks
Enable NetStream on the
incoming traffic of the
port
ip netstream inbound
Required
Disabled by default.
Enable the ACSEI client
function
acsei-client enable Required
Exit the Ethernet interface
view and enter system
view
quit Required
Configure the destination
address for the IPv4
NetStream traditional
data export
ip netstream export host ip-address udp-port
Required
Use either approach.
Configure the destination
address for the IPv4
NetStream aggregation
data export
Enter the protocol-port aggregation view:
ip netstream aggregation protocol-port
Configure the destination address for data export:
ip netstream export host ip-addrress udp-port
Enable the aggregation mode:
enable
Exit to system view:
quit
Enter the view of the port
connected to the NSC
interface interface-type interface-number —
Assign an IP address to
the port ip address ip-address { mask | mask-length }
[ sub ]
Required
The IP address can be in the
same segment as the NSC,
or can be connected to the
NSC over an internet.
Configure a static route
ip route-static dest-address { mask | mask-length }
{ next-hop-address | interface-type
interface-number [ next-hop-address ] }
[ preference preference-value ] [ description
description-text ]
Required
Make sure the NS card and
the NSC can reach each
other.
Configuring the NSC
For information about NSC configuration, see the related documents for the NSC products. If you use the
IMC-NTA as the NSC, see the H3C SecBlade NS Card Configuration Examples.
IPv4 NetStream traditional data export
configuration example
Network requirements
A SecBlade NS card is inserted in the device for IP traffic statistics collection. GigabitEthernet 2/0/1 is
an internal network interface, and GigabitEthernet 2/0/2 is an external network interface of the device.