Deactive state, Active state, N in – H3C Technologies H3C SecBlade NetStream Cards User Manual
Page 260: Figure 73
245
Figure 73 Patches are not loaded to the memory patch area
NOTE:
Currently, the memory patch area supports up to 200 patches.
DEACTIVE state
Patches in the DEACTIVE state have been loaded to the memory patch area but have not yet run in the
system. Suppose that there are seven patches in the patch file to be loaded. After the seven patches
successfully pass the version check and CRC check, they are loaded to the memory patch area and are
in the DEACTIVE state. At this time, the patch states in the system are as shown in
.
Figure 74 A patch file is loaded to the memory patch area
ACTIVE state
Patches in the ACTIVE state have run temporarily in the system and become DEACTIVE after system
reboot. For the seven patches in
, if you activate the first five patches, their states change from
DEACTIVE to ACTIVE. The patch states in the system are as shown in
The patches that are in the ACTIVE state are in the DEACTIVE state after system reboot.
Patch 1 IDLE
Patch 2 IDLE
Patch 3 IDLE
Patch 4 IDLE
Patch 5 IDLE
Patch 6 IDLE
Patch 7 IDLE
Patch 8 IDLE
Memory patch area