H3C Technologies H3C SecBlade NetStream Cards - Manual (Page 284)

269
To do… Use the command… Remarks
Configure the output rules of
the system information
info-center source { module-name |
default } channel { channel-number |
channel-name } [ debug { level severity |
state state } * | log { level severity |
state state } * | trap { level severity |
state state } * ] *
Optional
See “
Default output rules of system
information .”
Configure the format of the
time stamp info-center timestamp { debugging | log
| trap } { boot | date | none }
Optional
The time stamp format for log, trap
and debugging information is date
by default.
Outputting system information to the log buffer
NOTE:
You can configure to output log, trap, and debugging information to the log buffer, but the log buffer
receives the log and debugging information only, and discards the trap information.
To do… Use the command… Remarks
Enter system view system-view —
Enable information center info-center enable
Optional
Enabled by default.
Name the channel with a specified
channel number
info-center channel
channel-number name
channel-name Optional
See
Table 19 for default channel
names.
Configure the channel through
which system information can be
output to the log buffer and specify
the buffer size
info-center logbuffer [ channel
{ channel-number |
channel-name } | size buffersize ]
*
Optional
By default, system information is
output to the log buffer through
channel 4 (known as logbuffer)
and the default buffer size is 512.
Configure the output rules of the
system information
info-center source { module-name |
default } channel { channel-number
| channel-name } [ debug { level
severity | state state } * | log { level
severity | state state } * | trap
{ level severity | state state } * ] *
Optional
See “
Default output rules of system
information .”
Configure the format of the time
stamp info-center timestamp { debugging
| log | trap } { boot | date | none }
Optional
The time stamp format for log, trap
and debugging information is date
by default.