H3C Technologies H3C SecBlade NetStream Cards - Manual (Page 285)

270
Outputting system information to the SNMP module
NOTE:
The SNMP module receives the trap information only, and discards the log and debugging information
even if you have configured to output them to the SNMP module.
To monitor the device running status, trap information is usually sent to the SNMP network management
station (NMS). In this case, you need to configure to send traps to the SNMP module, and then set the
trap sending parameters for the SNMP module to further process traps. For more information, see the
chapter “SNMP configuration.”
Follow these steps to configure to output system information to the SNMP module:
To do… Use the command… Remarks
Enter system view system-view —
Enable information center info-center enable
Optional
Enabled by default
Name the channel with a specified
channel number
info-center channel
channel-number name
channel-name
Optional
See
Table 19 for default channel
names.
Configure the channel through
which system information can be
output to the SNMP module
info-center snmp channel
{ channel-number |
channel-name }
Optional
By default, system information is
output to the SNMP module
through channel 5 (known as
snmpagent).
Configure the output rules of the
system information
info-center source { module-name |
default } channel { channel-number
| channel-name } [ debug { level
severity | state state } * | log { level
severity | state state } * | trap
{ level severity | state state } * ] *
Optional
See “
Default output rules of system
information .”
Configure the format of the time
stamp info-center timestamp { debugging
| log | trap } { boot | date | none }
Optional
The time stamp format for log, trap
and debugging information is date
by default.
Outputting system information to the web interface
This feature allows you to control whether to output system information to the web interface and which
system information can be output to the web interface. The web interface provides abundant search and
sorting functions; therefore, if you configure to output the system information to the web interface, you
can view system information by clicking corresponding tabs after logging in to the device through the
web interface.
Follow these steps to set to output system information to the web interface:
To do… Use the command… Remarks
Enter system view system-view —