H3C Technologies H3C SecBlade NetStream Cards - Manual (Page 252)

237
To do… Use the command… Remarks
Enter system view system-view —
Enable the automatic saving of
the running configuration, and set
the interval
archive configuration interval
minutes Optional
Disabled by default
NOTE:
The path and filename prefix for saving configuration files must be specified before you configure the
automatic saving period.
Manually saving the running configuration
Automatic saving of the running configuration occupies system resources, and frequent saving can
greatly affect system performance. Therefore, if the system configuration does not change frequently,
disable the automatic saving of the running configuration and save it manually.
In addition, automatic saving of the running configuration is performed periodically, while manual
saving can immediately save the running configuration. Before performing complicated configuration,
you can manually save the running configuration so that the device can revert to the previous state if and
when the configuration fails.
Follow the step below to manually save the running configuration:
To do… Use the command… Remarks
Manually save the running
configuration
archive configuration
Required
Available in user view
NOTE:
Specify the path and filename prefix of a save configuration file before you manually save the running
configuration; otherwise, the operation fails.
Setting configuration rollback
Follow these steps to set configuration rollback:
To do… Use the command… Remarks
Enter system view system-view —
Set configuration rollback configuration replace file filename Required