H3C Technologies H3C SecBlade NetStream Cards - Manual (Page 54)

39
To do… Use the command… Remarks
Set the idle-timeout
timer
idle-timeout minutes [ seconds ]
Optional
The default idle-timeout is 10
minutes for all user interfaces.
The system automatically
terminates the user’s connection if
there is no information interaction
between the SecBlade card and
the user in timeout time.
Setting idle-timeout to 0 disables
the timer.
Specify a command
to be automatically
executed when a user
logs in to the current
user interface
auto-execute command
command
Optional
By default, command
auto-execution is disabled.
The system automatically executes
the specified command when a
user logs in to the user interface,
and tears down the user
connection after the command is
executed. If the command triggers
another task, the system does not
tear down the user connection until
the task is completed. A telnet
command is usually specified to
enable the user to automatically
telnet to the specified SecBlade
card.
CAUTION:
The auto-execute command command may disable you from configuring the system through the user
interface to which the command is applied. Before configuring the command and saving the configuration
(by using the save command), make sure that you can access the SecBlade card through VTY, TTY,
console, or AUX interfaces to remove the configuration when a problem occurs.
Configuring the SecBlade card to log in to a telnet server as a
telnet client
Configuration prerequisites
You have logged in to SecBlade card.
By default, you can log in to the SecBlade card through the console port without authentication and have
user privilege level 3 after login. For information about logging in to the SecBlade card with the default
configuration, see “ Configuration requirements .”