H3C Technologies H3C SecBlade NetStream Cards - Manual (Page 58)

43
To do… Use the command… Remarks
Reset the system of
the SecBlade NS
card
• When the host device works in standalone mode:
oap reboot slot slot-number
• When the host device works in IRF mode:
oap reboot chassis chassis-number slot slot-number
Configure at least one
command.
Available in user view
CAUTION:
Reset of the SecBlade NS card may cause data loss and service interruption. Therefore, before resetting
the SecBlade NS card, save the configurations on the operating system of the SecBlade NS card and shut
down the operating system of the SecBlade NS card to avoid service interruption and hardware data loss.
Configuring the ACSEI Protocol
As a private protocol, ACSEI provides a method for exchanging information between ACFP clients and
ACFP server. It well supports Application Control Forwarding Protocol (ACFP) collaboration, ensuring
valid information interaction between the ACFP clients and the ACFP server, so that the ACFP server and
clients can cooperate to run a service.
As a supporting protocol of ACFP, ACSEI also has two entities: server and client.
• ACSEI server is integrated into the software system (Comware) of the host device and is supported
by the host device.
• ACSEI client is implemented in two ways. One way is to integrate it into the system software
(Comware) of the SecBlade NetStream card. In this way it is a function supported by the NetStream
card.
ACSEI timers
An ACSEI server uses two timers, the clock synchronization timer and the monitoring timer.
• The clock synchronization timer is used to periodically trigger the ACSEI server to send clock
synchronization advertisements to ACSEI clients. You can set this timer through command lines.
• The monitoring timer is used to periodically trigger the ACSEI server to send monitoring requests to
ACSEI clients. You can set this timer through command lines.
An ACSEI client starts two timers, the registration timer and the monitoring timer.
• The registration timer is used to periodically trigger the ACSEI client to multicast registration requests
(with the multicast MAC address being 010F-E200-0021). You cannot set this timer.
• The monitoring timer is used to periodically trigger the ACSEI client to send monitoring requests to
the ACSEI server. You cannot set this timer.
ACSEI startup and running
ACSEI starts up and runs in the following procedures:
1. Enable ACSEI client on the NetStream card.
2. Start up the host device and enable the ACSEI server function on it.
3. The ACSEI client multicasts registration requests.