beautypg.com

Network requirements – H3C Technologies H3C SecBlade NetStream Cards User Manual

Page 184

background image

169

[Device-GigabitEthernet3/0/1] quit

# Enable ACSEI server for the NS card to synchronize the clock on the Device.

[Device] acsei server enable

2.

Configure the SecBlade NS card

# Enable IPv6.

system-view
[SecBlade] ipv6

# Configure Ten-GigabitEthernet 0/0 as a trunk port, and configure the port to allow packets from VLAN
10 and VLAN 20 to pass through.

[SecBlade] interface ten-gigabitethernet 0/0
[SecBlade-Ten-GigabitEthernet0/0] port link-type trunk
[SecBlade-Ten-GigabitEthernet0/0] port trunk permit vlan 10 20
[SecBlade-Ten-GigabitEthernet0/0] quit

# Create a blackhole-type inline forwarding entry 1.

[SecBlade] inline-interfaces 1 blackhole

# Assign Ten-GigabitEthernet 0/0 to the blackhole-type inline forwarding entry 1 for discarding the
packets when they are received and processed.

[SecBlade] interface ten-gigabitethernet 0/0
[SecBlade-Ten-GigabitEthernet0/0] port inline-interfaces 1

# Enable IPv6 NetStream for incoming traffic on Ten-GigabitEthernet 0/0.

[SecBlade-Ten-GigabitEthernet0/0] ipv6 netstream inbound

# Enable ACSEI client on Ten-GigabitEthernet 0/0 to synchronize the clock on the Device.

[SecBlade-Ten-GigabitEthernet0/0] acsei-client enable
[SecBlade-GigabitEthernet0/0] quit

# Assign an IP address to interface GigabitEthernet 0/1.

[SecBlade] interface gigabitethernet 0/1
[SecBlade-GigabitEthernet0/1] ip address 12.110.2.1 255.255.255.0
[SecBlade-GigabitEthernet0/1] quit

# Configure the destination address for the IPv6 NetStream data export with the IP address 12.110.2.2
and port 5000.

[SecBlade] ipv6 netstream export host 12.110.2.2 5000

IPv6 NetStream aggregation data export
configuration example

Network requirements

As shown in

Figure 53

, configure IPv6 NetStream on SecBlade NS card so that:

The card exports IPv6 NetStream traditional data to port 5000 of the NSC at 12.110.2.2/24.

The card performs IPv6 NetStream aggregation in the protocol-port mode, and sends the
aggregation data to the destination address with UDP port 3000.