H3C Technologies H3C SecBlade IPS Cards - Manual (Page 81)

10-2
Figure 10-1 Interface status synchronization
Table 10-1 describes the configuration items for setting interface status synchronization.
Table 10-1 Configuration items for setting interface status synchronization
Item Remarks
Device Access Mode
Set the interface status synchronization mode of the device: Hub, Breaker or
Wire.
Synchronize After
Set the validation waiting time for an interface to change to a new status.
If you select the Breaker or Wire mode, this item is configurable.
When the interface status synchronization mode of the device is set to Wire, a
short validation waiting time for an interface to change to a new status may easily
cause interface pair flapping, so set a longer one.