H3C Technologies H3C SecBlade IPS Cards - Manual (Page 63)

5-3
Select System Management > Network Management > Management Interface from the navigation
tree to enter the page as shown in Figure 5-2 . On the Management Interface Configuration tab, you
can view and configure parameters including the IP address and mask of a specific management
interface, and the status of HTTP, HTTPS, SSH, and Telnet.
Figure 5-2 Management interface configuration
Table 5-1 describes the configuration items of management interface parameters.
Table 5-1 Management interface parameter configuration items
Item Description
Management Interface Select an interface to be configured.
IP Address Specify an IP address and a subnet mask for the management interface.
Protocol
Enable or disable HTTP, HTTPS, SSH and Telnet.
z This configuration item is effective globally.
z The total number of HTTP and HTTPS connections on the device cannot
exceed 5. The total number of SSH and Telnet connections on the device
cannot exceed 7.
z You are not recommended to log in to the Web network management
interface on a host through HTTP and HTTPS at the same time.