H3C Technologies H3C SecBlade IPS Cards - Manual (Page 77)

8-4
Item Description
Internal Interface
Specifies the internal interface of the segment. The card is connected to the host device
through this interface.
Return to Segment configuration task list .
Applying a Segment Bandwidth Control Scheme to the Segment
Select System Management > Network Management > Interface Configuration from the navigation
tree to enter the page as shown in Figure 8-1 or Figure 8-3 .
Table 8-4 describes the segment bandwidth control configuration items.
Table 8-4 Segment bandwidth control configuration items
Item Description
Segment List
This field displays basic information about all segments.
Select a segment that you want to apply the segment bandwidth control scheme to.
Up Set the bandwidth upper limit for traffic from the internal zone to the external zone. Configure
Segment
Bandwidth
Control
Down Set the bandwidth upper limit for traffic from the external zone to the internal zone
Return to Segment configuration task list .
Precautions
Before creating a segment, you must configure security zones and assign at least one interface to each
security zone configured on a card. For more information, see Configuring a Security Zone .