H3C Technologies H3C SecBlade IPS Cards User Manual
Page 215
23-2
describes the items of querying virus reports.
Table 23-2 Items of querying virus reports
Item
Description
Report Type
Specify the type of the virus report to be viewed, which can be:
z
Virus event report
z
Virus source report
z
Virus destination report
Virus name/Source
IP/Destination IP
Set the name/source IP/destination IP of the virus.
z
When the Report Type is Virus event report, this parameter is Virus Name.
z
When the Report Type is Virus source report, this parameter is Source IP.
z
When the Report Type is Virus destination report, this parameter is Destination
IP.
Virus Category
Set the category for the viruses. The virus category supported by the device is issued
by the system by default.
Action
Specify the action against the virus, which can be Alert or Block.
Segment
Specify the segment where viruses occur.
Select System Management > Network Management > Segment Configuration to
configure the segments available for selection.
Time Range
Specify the time range of the traffic statistics report to be viewed, which can be:
z
Last hour: Displays the statistics of the last full hour. For example, suppose it is
16:25 now, the statistics between 15:00 and 16:00 today are displayed.
z
Last day: Displays the statistics of the last day. For example, suppose it is
2008-08-08 today, the statistics between 2008-08-07 00:00 and 2008-08-08 00:00
are displayed.
z
Last week: Displays the statistics of the last week. For example, suppose it is
Wednesday today, the statistics between the last Wednesday and the current
Tuesday are displayed.
z
Customize: Displays the traffic statistics of the specified time range. You need to
manually set the start time and the end time.
After setting the query conditions, click Query and the report information conforming to the set query
conditions is displayed on the lower part of the page, as shown in