H3C Technologies H3C SecBlade IPS Cards User Manual
Page 211
22-2
describes the items of querying attack reports.
Table 22-2 Items of querying attack reports
Item
Description
Report Type
Specify the type of the attack report to be viewed, which can be:
z
Attack event report
z
Attack source report
z
Attack destination report
Attack ID/Source
IP/Destination IP
Set the attack ID/source IP/destination IP.
z
When the Report Type is Attack event report, this parameter is Attack ID.
z
When the Report Type is Attack source report, this parameter is source IP.
z
When the Report Type is Attack destination report, this parameter is destination
IP.
Severity
Set the severity level of attacks, which can be Critical, Error, Warning, and
Informational.
Action
Specify the action against the attack, which can be Alert or Block.
Segment
Specify the segment where attacks occur.
Select System Management > Network Management > Segment Configuration to
configure the segments available for selection.
Time Range
Specify the time range of the traffic statistics report to be viewed, which can be:
z
Last hour: Displays the statistics in the last full hour. For example, suppose it is 16:25
now, the statistics between 15:00 and 16:00 today are displayed.
z
Last day: Displays the statistics of the last day. For example, suppose it is 2008-08-08
today, the statistics between 2008-08-07 00:00 and 2008-08-08 00:00 are displayed.
z
Last week: Displays the statistics of the last week. For example, if it is Wednesday
today, the statistics between the last Wednesday and the current Tuesday are
displayed.
z
Customize: Displays the traffic statistics of the specified time range. You need to
manually set the start time and the end time.
After setting the query conditions, click Query and the report information conforming to the set query
conditions is displayed on the lower part of the page, as shown in