H3C Technologies H3C SecBlade IPS Cards - Manual (Page 206)

21-2
Configuring Traffic Statistics Reports
Select Report > Traffic Statistics Report > Traffic Statistics Report Configuration to enter the page
shown in Figure 21-1 . You can set the traffic statistics report on the upper part of the page and query
existing traffic statistics reports by type on the lower part of the page.
Figure 21-1 Traffic statistics report configuration
Table 21-3 describes the traffic statistics report configuration items.
Table 21-3 Traffic statistics configuration items
Item Remarks
Report Type
Specify the type of the traffic statistics report to be added, which can be:
z service report: service-based traffic statistics report
z protocol report: protocol-based traffic statistics report
Report Name Set the name for the traffic statistics report.
Segments
Specify the segments whose traffic is to be collected by the traffic statistics report.
Select System Management > Network Management > Segment Configuration to
configure the segments available for selection.
Direction
Specify the direction whose traffic is to be collected by the traffic statistics report, which can
be:
z Inbound
z Outbound
z Bidirectional
Service
List/Select
Protocol
Specify the service/protocol whose traffic is to be collected by the traffic statistics report.
Select Bandwidth Management > Service Management to configure the services
available for selection; select Bandwidth Management > Protocol Management to
configure the protocols available for selection.
z When the Report Type is service report, this parameter is Service List.
z When the Report Type is protocol report, this parameter is Select Protocol. To select
a protocol, click the Select Protocol button, and then a protocol list page appears.
Select a protocol on the page, and then click OK.
Return to Traffic statistics report configuration task list .