Configuring protocols – H3C Technologies H3C SecBlade IPS Cards User Manual
Page 181
18-2
Table 18-1 Bandwidth management configuration task list
Task
Remarks
Optional
Configure protocols for a service.
Optional
Specify a service for a bandwidth management policy.
Creating and Applying a
Bandwidth Management Policy
Required
Create a bandwidth management policy, configure rules for the bandwidth
management policy, and apply the policy to a segment.
By default, a bandwidth management policy named Service Control
Policy exists. You can modify and apply the policy, but cannot delete the
policy.
Activating the Configuration
Required
Activate the protocol, service, policy, rule, and policy application
configurations to make the configurations take effect.
z
There are two categories of configurations in the system: Class A and
Class B. Class A configurations take effect immediately, while Class B
configurations must be activated to take effect.
z
The Activate button is present on all pages with Class B
configurations. Clicking the button on any page will activate all Class B
configurations. You are recommended to complete all Class B
configurations before clicking the Activate button.
Configuring Protocols
z
In the navigation tree, protocols marked with red exclamation points are system-defined protocols.
Support for system-defined protocols depends on your device model.
z
For how to write user-defined protocol files, see
.
Select Bandwidth Management > Protocol Management from the navigation tree to enter the page
displaying all protocol information, as shown in