H3C Technologies H3C SecBlade IPS Cards - Manual (Page 15)

1-2
Step2 Configure an IP address for the PC and ensure that the PC and device can communicate with each
other.
Modify the IP address to one within the network segment 192.168.1.0/24 (except for 192.168.1.1), for
example, 192.168.1.2.
Step3 Launch the IE browser, and input the login information.
On the PC, launch the IE browser, type https://192.168.1.1 in the address bar (the HTTPS service is
enabled by default), and press Enter. You can enter the login page of the Web interface, as shown in
Figure 1-2 .
Click Chinese or English on the login page, input the username (admin) password (admin), and verify
code shown on the page, and click Login to enter the Web interface.
Figure 1-2 Login page of the Web interface
z The PC where you configure the device is not necessarily the Web-based network management
terminal.
z After the first-time login, you are recommended to change the default password. For detailed
operation, refer to User Management.
z A verify code will expire in 2 minutes, so you need to use the code within the expiration time. To
obtain a new verify code, click the verify code image.
z Up to 5 users can concurrently log in to the device through the Web interface.
Logging Out of the Web Interface
Click Logout in the upper-right corner of the Web interface. The system gives a confirmation dialog box,
on which you can click OK to quit Web-based network management.