beautypg.com

Configuration procedure – H3C Technologies H3C MSR 5600 User Manual

Page 98

background image

85

Figure 32 Network diagram

Configuration procedure

1.

Set the IP address for each interface as shown in

Figure 32

. (Details not shown.)

2.

Configure Device A:
# Enable the NTP service.

system-view

[DeviceA] ntp-service enable

# Specify the local clock as the reference source, with the stratum level 3.

[DeviceA] ntp-service refclock-master 3

3.

Configure Device B:
# Enable the NTP service.

system-view

[DeviceB] ntp-service enable

# Specify Device A as the IPv6 NTP server of Device B.

[DeviceB] ntp-service ipv6 unicast-server 3000::34

4.

Configure Device C:
# Enable the NTP service.

system-view

[DeviceC] ntp-service enable

# Specify the local clock as the reference source, with the stratum level 2.

[DeviceC] ntp-service refclock-master 2

# Configure Device B as an IPv6 symmetric passive peer.

[DeviceC] ntp-service ipv6 unicast-peer 3000::35

5.

Verify the configuration:
# After the configuration, Device B has two time servers Device A and Device C. Device C has a

lower stratum level than Device A, so Device B selects Device C as a reference clock to synchronize
to Device C. After synchronization, view the status of Device B. The output shows that Device B has

been synchronized to Device C.

[DeviceB] display ntp-service status

Clock status: synchronized

Device A

NTP server

Device B

NTP client/

symmetric passive peer

Device C

Symmetric active peer

3000::34/64

3000::35/64

3000::36/64

This manual is related to the following products: