beautypg.com

Configuration procedure – H3C Technologies H3C MSR 5600 User Manual

Page 100

background image

87

Figure 33 Network diagram

Configuration procedure

1.

Set the IP address for each interface as shown in

Figure 33

. (Details not shown.)

2.

Configure Router C:
# Enable the NTP service.

system-view

[RouterC] ntp-service enable

# Specify the local clock as the reference source, with the stratum level 2.

[RouterC] ntp-service refclock-master 2

# Configure Router C to operate in broadcast server mode and send broadcast messages through

Ethernet 1/1.

[RouterC] interface ethernet 1/1

[RouterC-Ethernet1/1] ntp-service broadcast-server

3.

Configure Router A:
# Enable the NTP service.

system-view

[RouterA] ntp-service enable

# Configure Router A to operate in broadcast client mode and receive broadcast messages on

Ethernet 1/1.

[RouterA] interface ethernet 1/1

[RouterA-Ethernet1/1] ntp-service broadcast-client

4.

Configure Router B:
# Enable the NTP service.

system-view

[RouterB] ntp-service enable

# Configure Router B to operate in broadcast client mode and receive broadcast messages on
Ethernet 1/1.

[RouterB] interface ethernet 1/1

[RouterB-Ethernet1/1] ntp-service broadcast-client

5.

Verify the configuration:

Eth1/1

3.0.1.31/24

Eth1/1

3.0.1.32/24

Router A

NTP broadcast client

Router C

NTP broadcast server

Router B

NTP broadcast client

Eth1/1
3.0.1.30/24

This manual is related to the following products: