H3C Technologies H3C MSR 5600 - Manual (Page 181)

168
Operation Description XML example
CLI
Executes CLI operations. A
request message encloses
commands in the
element, and a response
message encloses the command
output in the element.
NETCONF supports the
following views:
• Execution—Use view
• Configuration—System view
To execute a command in other
views, specify the command for
entering the specified view, and
then the desired command.
To execute the display this command in system view:
xmlns="urn:ietf:params:xml:ns:netconf:ba
se:1.0">
display
this
save
Saves the running configuration.
You can use the element
to specify a file for saving the
configuration. If you do not
specify a file, the running
configuration is saved to the
main startup configuration file.
To save the running configuration to the file test.cfg:
xmlns="urn:ietf:params:xml:ns:netconf:ba
se:1.0">
test.cfg
load
Loads the configuration. After
the device finishes the load
operation, the configuration in
the specified file is merged into
the current configuration of the
device.
To merge the configuration in the file a1.cfg to the
current configuration of the device:
xmlns="urn:ietf:params:xml:ns:netconf:ba
se:1.0">
a1.cfg
rollback
Rolls back the configuration. To
do so, you must specify the
configuration file in the
element. After the device
finishes the rollback operation,
the current device configuration
is totally replaced with the
configuration in the specified
configuration file.
To roll back the current configuration to the
configuration in the file 1A.cfg:
xmlns="urn:ietf:params:xml:ns:netconf:ba
se:1.0">
1A.cfg