Ftp operation configuration example, Network requirements, Configuration procedure – H3C Technologies H3C MSR 5600 User Manual
Page 51
38
[DeviceA] display nqa history admin test
NQA entry (admin admin, tag test) history records:
Index Response Status Time
1 62 Succeeded 2011-11-10 10:49:37.3
The output shows that Device A uses 62 milliseconds to translate domain name host.com into an IP
address.
FTP operation configuration example
Network requirements
As shown in
, configure an FTP operation to test the time required for Device A to upload a file
to the FTP server. The login username is admin, the login password is systemtest, and the file to be
transferred to the FTP server is config.txt.
Figure 10 Network diagram
Configuration procedure
# Assign each interface an IP address. (Details not shown.)
# Configure static routes or a routing protocol to make sure the devices can reach each other. (Details not
shown.)
# Create an FTP operation.
[DeviceA] nqa entry admin test1
[DeviceA-nqa-admin-test1] type ftp
# Specify the URL of the FTP server, and set the username and the password.
[DeviceA-nqa-admin-test1-ftp] url ftp://10.2.2.2
[DeviceA-nqa-admin-test1-ftp] username admin
[DeviceA-nqa-admin-test1-ftp] password cipher systemtest
# Specify 10.1.1.1 as the source IP address.
[DeviceA-nqa-admin-test1-ftp] source ip 10.1.1.1
# Configure the device to upload file config.txt to the FTP server.
[DeviceA-nqa-admin-test1-ftp] operation put
[DeviceA-nqa-admin-test1-ftp] filename config.txt
# Enable the saving of history records.
[DeviceA-nqa-admin-test1-ftp] history-record enable
[DeviceA-nqa-admin-test1-ftp] quit
# Start the FTP operation.
[DeviceA] nqa schedule admin test1 start-time now lifetime forever
# After the FTP operation runs for a period of time, stop the operation.
[DeviceA] undo nqa schedule admin test1