beautypg.com

Configuring the icmp template, Configuring the dns template – H3C Technologies H3C MSR 5600 User Manual

Page 42

background image

29

Configuring the ICMP template

A feature that uses the ICMP template creates and starts the ICMP operation to measure the reachability

of a destination device. The ICMP template is supported in both IPv4 and IPv6 networks.
To configure the ICMP template:

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Create an ICMP template and
enter its view.

nqa template icmp name N/A

3.

(Optional.) Specify the

destination IPv4 or IPv6
address of the operation.

IPv4 address:

destination ip ip-address

IPv6 address:

destination ipv6

ipv6-address

By default, no destination IP address
is configured.

4.

Specify the payload size in
each ICMP request.

data-size size

The default setting is 100 bytes.

5.

Specify the string to be filled in
the payload of each request.

data-fill string

The default setting is the
hexadecimal number

00010203040506070809.

Configuring the DNS template

A feature that uses the DNS template creates and starts the DNS operation to determine the status of the

server. It is supported in both IPv4 and IPv6 networks.
In DNS template view, you can specify the address expected to be returned. If the returned IP address is
the same as the expected address, the DNS server is valid and the operation succeeds. Otherwise, the

operation fails.
Create a mapping between the domain name and an address before you perform the DNS operation.

For information about configuring the DNS server, see Layer 3—IP Services Configuration Guide.
To configure the DNS template:

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Create a DNS template and

enter DNS template view.

nqa template dns name N/A

3.

(Optional.) Specify the DNS
server's IPv4 or IPv6 address.

IPv4 address:
destination ip ip-address

IPv6 address:

destination ipv6 ipv6-address

By default, the IP address of the
DNS server is not specified.

4.

Configure the destination port
number for the operation.

destination port port-number

By default, the destination port
number is 53.

5.

Specify the domain name that
needs to be translated.

resolve-target domain-name

By default, no domain name is
specified.

This manual is related to the following products: