Configuring snmp basic parameters, Configuring snmpv1 or snmpv2c basic parameters – H3C Technologies H3C MSR 5600 User Manual
Page 122
109
Configuring SNMP basic parameters
SNMPv3 differs from SNMPv1 and SNMPv2c in many ways. Their configuration procedures are
described in separate sections.
Configuring SNMPv1 or SNMPv2c basic parameters
SNMPv1 and SNMPv2c settings are supported only in non-FIPS mode.
To configure SNMPv1 or SNMPv2c basic parameters:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
(Optional.) Enable the
SNMP agent.
snmp-agent
By default, the SNMP agent is
disabled.
The SNMP agent is enabled when
you perform any command that
begins with snmp-agent except for
the snmp-agent
calculate-password command.
3.
(Optional.) Configure
the system contact.
snmp-agent sys-info contact sys-contact
The default is Hangzhou H3C Tech.
Co., Ltd.
4.
(Optional.) Configure
the system location.
snmp-agent sys-info location sys-location The default is Hangzhou, China.
5.
Enable SNMPv1 or
SNMPv2c.
snmp-agent sys-info version { all | { v1 |
v2c | v3 } * }
The default is SNMPv3.
6.
(Optional.) Change
the local engine ID.
snmp-agent local-engineid engineid
By default, the local engine ID is
the company ID plus the device ID.
7.
(Optional.) Create or
update a MIB view.
snmp-agent mib-view { excluded |
included } view-name oid-tree [ mask
mask-value ]
By default, the MIB view
ViewDefault is predefined. In this
view, all the MIB objects in the iso
subtree but the snmpUsmMIB,
snmpVacmMIB, and
snmpModules.18 subtrees are
accessible.
Each view-name oid-tree pair
represents a view record. If you
specify the same record with
different MIB sub-tree masks
multiple times, the most recent
configuration takes effect. Except
for the four sub-trees in the default
MIB view, you can create up to 16
unique MIB view records.