beautypg.com

Configuring ntp optional parameters, Specifying the source interface for ntp messages – H3C Technologies H3C MSR 5600 User Manual

Page 90

background image

77

Multicast server

Multicast client

Authentication

result

Enable

NTP

authentic

ation

Configure a

key and

configure it as

a trusted key

Associate the

key with a

multicast server

Enable NTP

authenticatio

n

Configure a

key and

configure it as

a trusted key

Yes No

Yes

No

N/A

No authentication.

NTP messages
can be sent and

received correctly.

Yes N/A

No

Yes

N/A

Failed. NTP
messages cannot

be sent and
received correctly.

Yes N/A

No

No

N/A

No authentication.
NTP messages

can be sent and

received correctly.

No N/A

N/A

Yes N/A

Failed. NTP
messages cannot
be sent and

received correctly.

No N/A

N/A

No

N/A

No authentication.
NTP messages

can be sent and

received correctly.

Configuring NTP optional parameters

The configuration tasks in this section are optional tasks. Configure them to improve NTP security,

performance, or reliability.

Specifying the source interface for NTP messages

To prevent interface status changes from causing NTP communication failures, configure the device to use

the IP address of an interface that is always up, for example, a loopback interface, as the source IP
address for the NTP messages to be sent. Set the loopback interface as the source interface so that any

interface status change on the device will not cause NTP messages to be unable to be received.
When the device responds to an NTP request, the source IP address of the NTP response is always the

IP address of the interface that has received the NTP request.
Follow these guidelines when you specify the source interface for NTP messages:

If you have specified the source interface for NTP messages in the ntp-service [ ipv6 ] unicast-server
or ntp-service [ ipv6 ] unicast-peer command, the interface specified in the ntp-service [ ipv6 ]

unicast-server or ntp-service [ ipv6 ] unicast-peer command serves as the source interface for NTP

messages.

If you have configured the ntp-service broadcast-server or ntp-service [ ipv6 ] multicast-server
command, the source interface for the broadcast or multicast NTP messages is the interface

configured with the respective command.

This manual is related to the following products: