beautypg.com

Ntp for mpls vpns, Protocols and standards, Configuration restrictions and guidelines – H3C Technologies H3C MSR 5600 User Manual

Page 77

background image

64

in the NTP message. If they are the same, the receiver accepts the message. Otherwise, it discards

the message.

NTP for MPLS VPNs

The device supports multiple VPN instances when it functions as an NTP client or a symmetric active peer
to realize time synchronization with the NTP server or symmetric passive peer in an MPLS VPN network.
Only the client/server and symmetric active/passive modes support VPN instances. For more

information about MPLS L3VPN, VPN instance, and PE, see MPLS Configuration Guide.
As

Figure 28

shows, users in VPN 1 and VPN 2 are connected to the MPLS backbone network through

provider edge (PE) devices, and services of the two VPNs are isolated. If you configure the PEs to operate
in NTP client or symmetric active mode, and specify the VPN to which the NTP server or NTP symmetric

passive peer belongs, the time synchronization between PEs and devices of the two VPNs can be

realized.

Figure 28 Network diagram

Protocols and standards

RFC 1305, Network Time Protocol (Version 3) Specification, Implementation and Analysis

RFC 5905, Network Time Protocol Version 4: Protocol and Algorithms Specification

Configuration restrictions and guidelines

You cannot configure both NTP and SNTP on the same device.

The NTP service and SNTP service are mutually exclusive. You can only enable either NTP service
or SNTP service at a time.

To ensure time synchronization accuracy, do not specify different reference sources for a symmetric
active peer and a symmetric passive peer when the symmetric active peer or symmetric passive peer
operates as the NTP client for the client/server mode, broadcast mode, or multicast mode.

This manual is related to the following products: