beautypg.com

Configuration procedure – H3C Technologies H3C MSR 5600 User Manual

Page 38

background image

25

The state of a reaction entry can be invalid, over-threshold, or below-threshold.

Before an NQA operation starts, the reaction entry is in invalid state.

If the threshold is violated, the state of the entry is set to over-threshold. Otherwise, the state of the
entry is set to below-threshold.

If the action to be triggered is configured as trap-only for a reaction entry, when the state of the entry
changes, a trap message is generated and sent to the NMS.

Configuration procedure

Before you configure threshold monitoring, configure the destination address of the trap messages by

using the snmp-agent target-host command. For more information about the command, see Network

Management and Monitoring Command Reference.
To configure threshold monitoring:

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Create an NQA

operation and
enter NQA

operation view.

nqa entry admin-name operation-tag

By default, no NQA operation
is created.

3.

Enter NQA

operation view.

type { dhcp | dlsw | dns | ftp | http | icmp-echo
| snmp | tcp | udp-echo | udp-jitter | voice }

Path jitter does not support the
threshold monitoring function.

4.

Enable sending

traps to the NMS
when specific

conditions are met.

reaction trap { probe-failure
consecutive-probe-failures | test-complete |

test-failure cumulate-probe-failures }

By default, no traps are sent to
the NMS.
The UDP jitter and voice

operations only support the
test-complete keyword.

This manual is related to the following products: