H3C Technologies H3C MSR 5600 - Manual (Page 152)

139
<getopration>
Specify the module, submodule, table name, and column name
getopration>
Where, the parameter can be or . The element is used to filter
data, and it can contain module name, submodule name, table name, and column name.
• If the module name and the submodule name are not provided, the operation retrieves the data for
all modules and submodules. If a module name or a submodule name is provided, the operation
retrieves the data for the specified module or submodule.
• If the table name is not provided, the operation retrieves the data for all tables. If a table name is
provided, the operation retrieves the data for the specified table.
• If only the index column is provided, the operation retrieves the data for all columns. If the index
column and other columns are provided, the operation retrieves the data for the index column and
the specified columns.
The and messages are similar. A message carries the count and index
attributes. The following is a message example:
xmlns:xc="http://www.h3c.com/netconf/base:1.0">
xmlns:base="http://www.h3c.com/netconf/base:1.0">
10
Where, the count attribute complies with the following rules:
• The count attribute can be placed in the module node and table node. In other nodes, it cannot be
resolved.
• When the count attribute is placed in the module node, a descendant node inherits this count
attribute if the descendant node does not contain the count attribute.
Verifying the configuration
After receiving the get-bulk request, the device returns a response in the following format if the operation
is successful: