Configuration procedure – H3C Technologies H3C MSR 5600 User Manual
Page 60
47
Figure 16 Network diagram
Configuration procedure
1.
Assign each interface an IP address. (Details not shown.)
2.
Configure static routes or a routing protocol to make sure the devices can reach each other.
(Details not shown.)
3.
Configure Device B:
# Enable the NQA server, and configure a listening service to listen on IP address 10.2.2.2 and
UDP port 9000.
[DeviceB] nqa server enable
[DeviceB] nqa server udp-echo 10.2.2.2 9000
4.
Configure Device A:
# Create a voice operation.
[DeviceA] nqa entry admin test1
[DeviceA-nqa-admin-test1] type voice
# Configure 10.2.2.2 as the destination IP address and port 9000 as the destination port.
[DeviceA-nqa-admin-test1-voice] destination ip 10.2.2.2
[DeviceA-nqa-admin-test1-voice] destination port 9000
[DeviceA-nqa-admin-test1-voice] quit
# Start the voice operation.
[DeviceA] nqa schedule admin test1 start-time now lifetime forever
# After the voice operation runs for a period of time, stop the operation.
[DeviceA] undo nqa schedule admin test1
# Display the results of the voice operation.
[DeviceA] display nqa result admin test1
NQA entry (admin admin, tag test1) test results:
Send operation times: 1000 Receive response times: 1000
Min/Max/Average round trip time: 31/1328/33
Square-Sum of round trip time: 2844813
Last packet received time: 2011-06-13 09:49:31.1
Extended results:
Packet loss ratio: 0%
Failures due to timeout: 0
Failures due to internal error: 0
Failures due to other errors: 0
Packets out of sequence: 0
Packets arrived late: 0
Voice results:
RTT number: 1000