Configuring the information center, Overview, Log types – H3C Technologies H3C MSR 5600 User Manual
Page 213: Log levels
200
Configuring the information center
NOTE:
FIPS is not available for Russia.
The information center on a device classifies and manages logs for all modules so that network
administrators can monitor network performance and troubleshoot network problems.
Overview
The information center receives logs generated by source modules and outputs logs to different
destinations according to user-defined output rules. You can classify, filter, and output logs based on
source modules. To view the supported source modules, use info-center source ?.
Figure 59 Information center diagram
By default, the information center is enabled. It affects system performance to some degree while
processing large amounts of information. If the system resources are insufficient, disable the information
center to save resources.
Log types
Logs fall into the following types:
•
Common logs—Record common system information. Unless otherwise specified, the term "logs" in
this document refers to common logs.
•
Diagnostic logs—Record debug messages.
•
Security logs—Record security information, such as authentication and authorization information.
•
Hidden logs—Record log information not displayed on the terminal, such as input commands.
Log levels
Logs are classified into eight severity levels from 0 through 7 in descending order. The router outputs logs
with a severity level that is higher than or equal to the specified level. For example, if you configure an
output rule with a severity level of 6 (informational), logs that have a severity level from 0 to 6 are output.