beautypg.com

Network requirements, Configuration procedure – H3C Technologies H3C MSR 5600 User Manual

Page 107

background image

94

Reference: 127.127.1.0 Clock stratum: 2

Reachabilities: 2 Poll interval: 64

Last receive time: 71 Offset: -0.0

Roundtrip delay: 0.0 Dispersion: 0.0

Total sessions : 1

The output shows that an association has been set up between Router A and Router C.

Configuration example for NTP client/server mode

with authentication

Network requirements

As shown in

Figure 36

, configure the local clock of Device A as a reference source, with the stratum

level 2.

Configure Device B to operate in client mode and specify Device A as the NTP server of Device B,
with Device B as the client.

Configure NTP authentication on both Device A and Device B.

Figure 36 Network diagram

Configuration procedure

1.

Set the IP address for each interface as shown in

Figure 36

. (Details not shown.)

2.

Configure Device A:
# Enable the NTP service.

system-view

[DeviceA] ntp-service enable

# Specify the local clock as the reference source, with the stratum level 2.

[DeviceA] ntp-service refclock-master 2

3.

Configure Device B:
# Enable the NTP service.

system-view

[DeviceB] ntp-service enable

# Enable NTP authentication on Device B.

[DeviceB] ntp-service authentication enable

# Set an authentication key, and input the key in plain text.

[DeviceB] ntp-service authentication-keyid 42 authentication-mode md5 simple

aNiceKey

# Specify the key as a trusted key.

[DeviceB] ntp-service reliable authentication-keyid 42

This manual is related to the following products: