H3C Technologies H3C MSR 5600 - Manual (Page 30)

17
Step Command Remarks
12. (Optional.) Specify the source
IP address for UDP packets.
source ip ip-address
By default, no source IP address is
specified.
The source IP address must be the
IP address of a local interface, and
the interface must be up.
Otherwise, no UDP packets can be
sent out.
NOTE:
Use the display nqa result command or the display nqa statistics command to verify the UDP jitter
operation. The display nqa history command does not display the UDP jitter operation results or statistics.
Configuring the SNMP operation
The SNMP operation measures the time for the NQA client to get a response packet from an SNMP
agent.
To configure the SNMP operation:
Step Command Remarks
1. Enter system view. system-view N/A
2. Create an NQA operation
and enter NQA operation
view.
nqa entry admin-name
operation-tag By default, no NQA operation is
created.
3. Specify the SNMP type and
enter its view.
type snmp N/A
4. Specify the destination
address of SNMP packets.
destination ip ip-address
By default, no destination IP address is
specified.
5. (Optional.) Specify the source
port of SNMP packets.
source port port-number
By default, no source port number is
specified.
6. (Optional.) Specify the source
IP address of SNMP packets. source ip ip-address
By default, no source IP address is
specified.
The source IP address must be the IP
address of a local interface, and the
interface must be up. Otherwise, no
SNMP packets can be sent out.
Configuring the TCP operation
The TCP operation measures the time for the NQA client to establish a TCP connection to a specific port
on the NQA server.
The TCP operation requires both the NQA server and the NQA client. Before you perform a TCP
operation, configure a TCP listening service on the NQA server. For more information about the TCP
listening service configuration, see " Configuring the NQA server ."
To configure the TCP operation: