beautypg.com

Network requirements, Configuration procedure – H3C Technologies H3C MSR 5600 User Manual

Page 204

background image

191

NetStream aggregation data export configuration

example

Network requirements

As shown in

Figure 56

, configure NetStream on Router A to meet the following requirements:

Router A exports NetStream traditional data in the version 5 export format to port 5000 of the
NetStream server at 4.1.1.1/16.

Router A performs NetStream aggregation in the modes of AS, protocol-port, source-prefix,
destination-prefix, and prefix. Use the version 8 export format to send the aggregation data of

different modes to the destination address at 4.1.1.1, with UDP ports 2000, 3000, 4000, 6000,

and 7000, respectively.

Figure 56 Network diagram

Configuration procedure

All routers in the network are running EBGP. For more information about BGP, see Layer 3IP Routing

Configuration Guide.
# Enable NetStream for incoming and outgoing traffic on Ethernet 1/1.

system-view

[RouterA] interface ethernet 1/1

[RouterA-Ethernet1/1] ip address 3.1.1.1 255.255.0.0

[RouterA-Ethernet1/1] ip netstream inbound

[RouterA-Ethernet1/1] ip netstream outbound

[RouterA-Ethernet1/1] quit

# In system view, configure the destination address as 4.1.1.1 and the destination UDP port number as
5000 for the NetStream traditional data export.

[RouterA] ip netstream export host 4.1.1.1 5000

# Configure the aggregation mode as AS, and then, in NetStream aggregation view, configure the
destination address as 4.1.1.1 and the destination UDP port number as 2000 for the NetStream AS

aggregation data export.

[RouterA] ip netstream aggregation as

This manual is related to the following products: