Displaying and maintaining nqa – H3C Technologies H3C MSR 5600 User Manual
Page 46
33
Step Command
Remarks
8.
Set the data
transmission mode.
mode { active | passive }
The default mode is active.
Configuring optional parameters for the NQA template
To configure optional parameters for an NQA template:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Create an NQA template
and enter its view.
nqa template { dns | ftp | http
| icmp | tcp } name
N/A
3.
Configure a description.
description text
By default, no description is configured.
4.
Specify the interval at
which the NQA operation
repeats.
frequency interval
The default setting is 5000 milliseconds.
If the operation is not completed when the
interval expires, the next operation does
not start.
5.
Specify the probe timeout
time.
probe timeout timeout
The default setting is 3000 milliseconds.
6.
Specify the TTL for probe
packets.
ttl value
The default setting is 20.
7.
(Optional.) Specify the
ToS value in the IP packet
header of probe packets.
tos value
The default setting is 0.
8.
Specify the VPN where
the operation is
performed.
vpn-instance
vpn-instance-name
By default, the operation is performed on
the public network.
9.
Configure the number of
consecutive successful
probes that lead to a
successful operation.
reaction trigger probe-pass
count
The default setting is 3.
10.
Configure the number of
consecutive probe failures
that lead to an operation
failure.
reaction trigger probe-fail
count
The default setting is 3.
11.
Configure the source IPv4
or IPv6 address for probe
packets.
•
IPv4 address:
source ip ip-address
•
IPv6 address:
source ipv6 ipv6-address
By default, no source IP address is
configured.
The specified source IP address must be the
IP address of a local interface, and the
interface must be up. Otherwise, no probe
packets can be sent out.
Displaying and maintaining NQA
Execute display commands in any view.