Nqa collaboration configuration example, Network requirements, Configuration procedure – H3C Technologies H3C MSR 5600 User Manual
Page 65
52
Min/Max/Average negative jitter: 2/10/6
Sum/Square-Sum positive jitter: 19/153
NQA collaboration configuration example
Network requirements
As shown in
, configure a static route to Router C with Router B as the next hop on Router A.
Associate the static route, a track entry, and an NQA operation to monitor the state of the static route.
Figure 19 Network diagram
Configuration procedure
1.
Assign each interface an IP address. (Details not shown.)
2.
On Router A, configure a unicast static route, and associate the static route with a track entry:
# Configure a static route, and associate the static route with track entry 1.
[RouterA] ip route-static 10.1.1.2 24 10.2.1.1 track 1
3.
On Router A, configure an ICMP echo operation:
# Create an NQA operation with the administrator name being admin and operation tag being
test1.
[RouterA] nqa entry admin test1
# Configure the NQA operation type as ICMP echo.
[RouterA-nqa-admin-test1] type icmp-echo
# Configure 10.2.2.1 as the destination IP address.
[RouterA-nqa-admin-test1-icmp-echo] destination ip 10.2.1.1
# Configure the operation to repeat at an interval of 100 milliseconds.
[RouterA-nqa-admin-test1-icmp-echo] frequency 100
# Create reaction entry 1. If the number of consecutive probe failures reaches 5, collaboration is
triggered.
[RouterA-nqa-admin-test1-icmp-echo] reaction 1 checked-element probe-fail
threshold-type consecutive 5 action-type trigger-only
[RouterA-nqa-admin-test1-icmp-echo] quit
# Start the ICMP echo operation.
[RouterA] nqa schedule admin test1 start-time now lifetime forever
4.
On Router A, create the track entry: