beautypg.com

Configuring the dlsw operation, Configuring the path jitter operation – H3C Technologies H3C MSR 5600 User Manual

Page 34

background image

21

Step Command

Remarks

12.

Specify the number of voice
packets to be sent in a voice

probe.

probe packet-number
packet-number

The default setting is 1000.

13.

Specify the interval for
sending voice packets.

probe packet-interval
packet-interval

The default setting is 20 milliseconds.

14.

Specify how long the NQA
client waits for a response

from the server before it

regards the response times
out.

probe packet-timeout

packet-timeout

The default setting is 5000
milliseconds.

NOTE:

Use the display nqa result command or the display nqa statistics command to verify the voice operation.
The display nqa history command does not display the voice operation results or statistics.

Configuring the DLSw operation

The DLSw operation measures the response time of a DLSw device.
To configure the DLSw operation:

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Create an NQA operation

and enter NQA operation
view.

nqa entry admin-name
operation-tag

By default, no NQA operation is
created.

3.

Specify the DLSw type and

enter its view.

type dlsw

N/A

4.

Specify the destination
address of probe packets.

destination ip ip-address

By default, no destination IP address
is specified.

5.

(Optional.) Specify the source
IP address of probe packets.

source ip ip-address

By default, no source IP address is
specified.
The source IP address must be the IP
address of a local interface, and the

interface must be up. Otherwise, no

probe packets can be sent out.

Configuring the path jitter operation

The path jitter operation measures the jitter, negative jitters, and positive jitters from the NQA client to

each hop on the path to the destination.
Before you configure the path jitter operation, perform the following configurations:

Enable sending ICMP time-exceeded packets on the intermediate devices between the source and
the destination devices. If the intermediate devices are H3C devices, use the ip ttl-expires enable

command.

This manual is related to the following products: