H3C Technologies H3C MSR 5600 - Manual (Page 83)

70
NTP server on the client. The key IDs and key values configured on the server and client must be the same.
Otherwise, NTP authentication fails.
To configure NTP authentication for a client:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable NTP authentication. ntp-service authentication enable
By default, NTP authentication is
disabled.
3. Configure an NTP
authentication key.
ntp-service authentication-keyid
keyid authentication-mode md5
{ cipher | simple } value
By default, no NTP authentication
key is configured.
4. Configure the key as a trusted
key.
ntp-service reliable
authentication-keyid keyid By default, no authentication key is
configured as a trusted key.
5. Associate the specified key
with an NTP server.
• Associate the specified key with
an NTP server:
ntp-service unicast-server
{ ip-address | server-name }
[ vpn-instance
vpn-instance-name ]
authentication-keyid keyed
• Associate the specified key with
an IPv6 NTP server
ntp-service ipv6 unicast-server
{ ipv6-address | server-name }
[ vpn-instance
vpn-instance-name ]
authentication-keyid keyid
By default, no NTP server is
specified.
To configure NTP authentication for a server:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable NTP authentication. ntp-service authentication enable
By default, NTP authentication is
disabled.
3. Configure an NTP
authentication key.
ntp-service authentication-keyid
keyid authentication-mode md5
{ cipher | simple } value
By default, no NTP authentication
key is configured.
4. Configure the key as a trusted
key. ntp-service reliable
authentication-keyid keyid By default, no authentication key is
configured as a trusted key.
NTP authentication results differ when different configurations are performed on client and server. For
more information, see
Table 3 . (N/A in the table means that whether the configuration is performed does
not make any difference.)