beautypg.com

Snmp operation configuration example, Network requirements, Configuration procedure – H3C Technologies H3C MSR 5600 User Manual

Page 56

background image

43

Number of SD delay: 410 Number of DS delay: 410

Sum of SD delay: 3705 Sum of DS delay: 3891

Square-Sum of SD delay: 45987 Square-Sum of DS delay: 49393

SD lost packets: 0 DS lost packets: 0

Lost packets for unknown reason: 0

SNMP operation configuration example

Network requirements

As shown in

Figure 13

, configure an SNMP operation to test the time the NQA client uses to get a value

from the SNMP agent.

Figure 13 Network diagram

Configuration procedure

1.

Assign each interface an IP address. (Details not shown.)

2.

Configure static routes or a routing protocol to make sure the devices can reach each other.
(Details not shown.)

3.

Configure the SNMP agent (Device B):
# Enable the SNMP agent, and set the SNMP version to all, the read community to public, and the
write community to private.

system-view

[DeviceB] snmp-agent sys-info version all

[DeviceB] snmp-agent community read public

[DeviceB] snmp-agent community write private

4.

Configure Device A:
# Create an SNMP operation, and configure 10.2.2.2 as the destination IP address.

system-view

[DeviceA] nqa entry admin test1

[DeviceA-nqa-admin-test1] type snmp

[DeviceA-nqa-admin-test1-snmp] destination ip 10.2.2.2

# Enable the saving of history records.

[DeviceA-nqa-admin-test1-snmp] history-record enable

[DeviceA-nqa-admin-test1-snmp] quit

# Start the SNMP operation.

[DeviceA] nqa schedule admin test1 start-time now lifetime forever

# After the SNMP operation runs for a period of time, stop the operation.

[DeviceA] undo nqa schedule admin test1

# Display the results of the SNMP operation.

[DeviceA] display nqa result admin test1

NQA entry (admin admin, tag test1) test results:

This manual is related to the following products: