Configuration procedure, Verifying the configuration – H3C Technologies H3C MSR 5600 User Manual
Page 186
173
Figure 50 Network diagram
Configuration procedure
# Create local mirroring group 1.
[Device] mirroring-group 1 local
# Configure Ethernet 1/1 and Ethernet 1/2 as source ports and port Ethernet 1/3 as the monitor port
for local mirroring group 1.
[Device] mirroring-group 1 mirroring-port ethernet 1/1 ethernet 1/2 both
[Device] mirroring-group 1 monitor-port ethernet 1/3
# Disable the spanning tree feature on the monitor port Ethernet 1/3.
[Device] interface ethernet 1/3
[Device-Ethernet1/3] undo stp enable
[Device-Ethernet1/3] quit
Verifying the configuration
# Display information about all mirroring groups.
[Device] display mirroring-group all
Mirroring group 1:
Type: Local
Status: Active
Mirroring port:
Ethernet1/1 Both
Ethernet1/2 Both
Monitor port: Ethernet1/3
After the configurations are completed, you can monitor all packets received and sent by the marketing
department and the technical department on the server.