beautypg.com

Configuration procedure, Verifying the configuration – H3C Technologies H3C MSR 5600 User Manual

Page 189

background image

176

Configure fixed sampling in the inbound direction to select the first packet from among 100

packets.

Configure random sampling in the outbound direction to select one packet randomly from among
200 packets.

Figure 51 Network diagram

Configuration procedure

# Create sampler 100 in fixed sampling mode, and set the rate to 100. The first packet of 100 packets

is selected.

system-view

[Device] sampler 100 mode fixed packet-interval 100

# Create sampler 200 in random sampling mode, and set the sampling rate to 200. One packet from
among 200 packets is selected.

[Device] sampler 200 mode random packet-interval 200

# Configure Ethernet 1/2, enable IPv4 NetStream to collect statistics about the incoming traffic, and then

configure the interface to use sampler 100.

[Device] interface ethernet 1/2

[Device-Ethernet1/2] ip address 11.110.2.1 255.255.0.0

[Device-Ethernet1/2] ip netstream inbound

[Device-Ethernet1/2] ip netstream sampler 100 inbound

# Configure Ethernet 1/2, enable IPv4 NetStream to collect statistics about outgoing traffic, and then
configure the interface to use sampler 200.

[Device-Ethernet1/2] ip netstream outbound

[Device-Ethernet1/2] ip netstream sampler 200 outbound

[Device-Ethernet1/2] quit

# Configure the address and port number of the NetStream server as the destination for the NetStream
data export. Use the default source interface for the NetStream data export.

[Device] ip netstream export host 12.110.2.2 5000

Verifying the configuration

# Execute the display sampler command on the device to view the configuration information about

sampler 100 and sampler 200.

[Device] display sampler 100

Sampler name: 100

Mode: Fixed; Packet-interval: 100

[Device] display sampler 200

Sampler name: 200

Mode: Random; Packet-interval: 200

This manual is related to the following products: