beautypg.com

H3C Technologies H3C MSR 5600 User Manual

Page 103

background image

90

Clock jitter: 0.044281 s

Stability: 0.000 pps

Clock precision: 2^-10

Root delay: 0.00229 ms

Root dispersion: 4.12572 ms

Reference time: d0d289fe.ec43c720 Sat, Jan 8 2011 7:00:14.922

The output shows that Router D has been synchronized to Router C, the clock stratum level of Router
D is 3, and the clock stratum level of Router C is 2.
# Display IPv4 NTP association information for Router D.

[RouterD-Ethernet1/1] display ntp-service sessions

source reference stra reach poll now offset delay disper

********************************************************************************

[1245]3.0.1.31 127.127.1.0 2 1 64 519 -0.0 0.0022 4.1257

Notes: 1 source(master),2 source(peer),3 selected,4 candidate,5 configured.

Total sessions : 1

The output shows that an association has been set up between Router D and Router C.

5.

Configure Router B:
Because Router A and Router C are on different subnets, you must enable the multicast functions on
Router B before Router A can receive multicast messages from Router C.
# Enable the IP multicast function.

system-view

[RouterB] multicast routing

[RouterB-mrib] quit

[RouterB] interface ethernet 1/1

[RouterB-Ethernet1/1] igmp enable

[RouterB-Ethernet1/1] igmp static-group 224.0.1.1

[RouterB-Ethernet1/1] quit

[RouterB] interface ethernet 1/2

[RouterB-Ethernet1/2] pim dm

6.

Configure Router A:
# Enable the NTP service.

system-view

[RouterA] ntp-service enable

# Configure Router A to operate in multicast client mode and receive multicast messages from

Ethernet 1/1.

[RouterA] interface ethernet 1/1

[RouterA-Ethernet1/1] ntp-service multicast-client

7.

Verify the configuration:
# Display the NTP status of Router A after clock synchronization.

[RouterA-Ethernet1/1] display ntp-service status

Clock status: synchronized

Clock stratum: 3

System peer: 3.0.1.31

Local mode: bclient

Reference clock ID: 3.0.1.31

This manual is related to the following products: