Outputting logs to the monitor terminal – H3C Technologies H3C MSR 5600 User Manual
Page 219
206
Step Command
Remarks
3.
Configure an output rule for
the console.
info-center source { module-name |
default } { console | monitor |
logbuffer | logfile | loghost }
{ deny | level severity }
For information about default
output rules, see "
4.
(Optional.) Configure the
timestamp format.
info-center timestamp { boot | date
| none }
By default, the timestamp format is
date.
5.
Return to user view.
quit
N/A
6.
Enable log output to the
console.
terminal monitor
The default setting is enabled.
7.
(Optional.) Enable the display
of debug information on the
current terminal.
terminal debugging
By default, the display of debug
information is disabled both on the
console and the monitor terminal.
8.
(Optional.) Set the lowest
severity level of logs that can
be output to the console.
terminal logging level severity
The default setting is 6
(Informational).
Outputting logs to the monitor terminal
Monitor terminals refer to terminals that log in to the device through the AUX, VTY, or TTY user interface.
To output logs to the monitor terminal:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enable the information center. info-center enable
By default, the information center is
enabled.
3.
Configure an output rule for
the monitor terminal.
info-center source { module-name |
default } { console | monitor |
logbuffer | logfile | loghost }
{ deny | level severity }
For information about default
output rules, see "
4.
(Optional.) Configure the
timestamp format.
info-center timestamp { boot | date
| none }
By default, the timestamp format is
date.
5.
Return to user view.
quit
N/A
6.
Enable log output to the
monitor terminal.
terminal monitor
The default setting is enabled.
7.
(Optional.) Enable the display
of debug information on the
current terminal.
terminal debugging
By default, the display of debug
information is disabled both on the
console and the monitor terminal.
8.
(Optional.) Set the lowest level
of logs that can be output to
the monitor terminal.
terminal logging level severity
The default setting is 6
(Informational).