beautypg.com

Dlsw operation configuration example, Network requirements, Configuration procedure – H3C Technologies H3C MSR 5600 User Manual

Page 62

background image

49

Max negative SD: 360 Max negative DS: 1297

Negative SD number: 1028 Negative DS number: 1022

Negative SD sum: 1028 Negative DS sum: 1022

Negative SD average: 4 Negative DS average: 5

Negative SD square-sum: 495901 Negative DS square-sum: 5419

One way results:

Max SD delay: 359 Max DS delay: 985

Min SD delay: 0 Min DS delay: 0

Number of SD delay: 4 Number of DS delay: 4

Sum of SD delay: 1390 Sum of DS delay: 1079

Square-Sum of SD delay: 483202 Square-Sum of DS delay: 973651

SD lost packets: 0 DS lost packets: 0

Lost packets for unknown reason: 0

Voice scores:

Max MOS value: 4.38 Min MOS value: 4.38

Max ICPIF value: 0 Min ICPIF value: 0

DLSw operation configuration example

Network requirements

As shown in

Figure 17

, configure a DLSw operation to test the response time of the DLSw device.

Figure 17 Network diagram

Configuration procedure

# Assign each interface an IP address. (Details not shown.)
# Configure static routes or a routing protocol to make sure the devices can reach each other. (Details not

shown.)
# Create a DLSw operation, and configure 10.2.2.2 as the destination IP address.

system-view

[DeviceA] nqa entry admin test1

[DeviceA-nqa-admin-test1] type dlsw

[DeviceA-nqa-admin-test1-dlsw] destination ip 10.2.2.2

# Enable the saving of history records.

[DeviceA-nqa-admin-test1-dlsw] history-record enable

[DeviceA-nqa-admin-test1-dlsw] quit

# Start the DLSw operation.

[DeviceA] nqa schedule admin test1 start-time now lifetime forever

# After the DLSw operation runs for a period of time, stop the operation.

[DeviceA] undo nqa schedule admin test1

# Display the results of the DLSw operation.

This manual is related to the following products: