H3C Technologies H3C S7500E Series Switches - Manual (Page 57)

4-4
Configure automatic ONU binding
With automatic ONU binding configured, the device automatically binds the current quiet ONU MAC
addresses to the ONU ports and generate the binding configuration on the ONU ports, and the ONUs
joining subsequently will also be bound automatically.
This binding method is applicable to occasions where the registration of invalid ONUs is not taken into
consideration and the ONUs attached to the OLT are completely trusted. In this way, concern about
binding is completely ignored. In this case, to remove a binding, disable automatic ONU binding first.
Otherwise, the removed ONU will be automatically bound again only if goes online.
Follow these steps to configure batch ONU binding:
To do… Use the command… Remarks
Enter system view system-view —
Enter FTTH view ftth —
Configure automatic ONU binding onu bind auto [ slot slot-id ]
Required
By default, automatic ONU binding
is disabled.
Neither batch ONU binding nor automatic ONU binding conflicts with the configuration of binding the
specified ONU to the specified ONU port. However, batch ONU binding conflicts with automatic ONU
binding.
Configuring the Management VLAN of the ONU
To manage an ONU through Telnet, make sure the ONU is assigned an IP address. Only the VLAN
interface corresponding to the management VLAN can be assigned an IP address. You can designate
the management VLAN through the command line.
The management VLAN interface of an ONU can obtain an IP address in one of the following two
ways:
Through manual configuration of IP addresses
Through DHCP (with the ONU as a DHCP client)
Follow these steps to configure the management VLAN of the ONU
To do... Use the command... Remarks
Enter system view system-view —
Enter ONU port view interface onu interface-number —