H3C Technologies H3C S7500E Series Switches - Manual (Page 51)

3-9
To do... Use the command... Remarks
Display the configuration
information in the current view
display this
To display the information about an ONU, make sure the ONU is online. You can use the display
onuinfo command to check whether an ONU is online.
Port statistics data includes average error rate of data bits and data frames transmitted between
an OLT and the ONUs. For detailed information, refer to OLT Configuration Commands in the
Layer 2 - LAN Switching Configuration Guide.
OLT Configuration Examples
OLT Port Isolation Configuration Example
Network requirements
An OLT device is connected to the Internet through the uplink port.
Configure port isolation between OLT 3/0/1 and OLT 3/0/2 so that the users under OLT 3/0/1 and
those under OLT 3/0/2 can access the Internet but cannot communicate with each other at Layer
2.
Network diagram
Figure 3-1 Network diagram for OLT port isolation
Configuration procedure
# Add OLT 3/0/1 and OLT 3/0/2 to an isolation group.
system-view