H3C Technologies H3C S7500E Series Switches User Manual

Page 146

11-22

[DeviceA-vlan20] quit

# Create Layer 2 aggregate interface 1, and configure the link aggregation mode as dynamic.

[DeviceA] interface bridge-aggregation 1

[DeviceA-Bridge-Aggregation1] link-aggregation mode dynamic

[DeviceA-Bridge-Aggregation1] quit

# Assign ports GigabitEthernet 2/0/1 through GigabitEthernet 2/0/3 to link aggregation group 1.

[DeviceA] interface gigabitethernet 2/0/1

[DeviceA-gigabitethernet2/0/1] port link-aggregation group 1

[DeviceA-gigabitethernet2/0/1] quit

[DeviceA] interface gigabitethernet 2/0/2

[DeviceA-gigabitethernet2/0/2] port link-aggregation group 1

[DeviceA-gigabitethernet2/0/2] quit

[DeviceA] interface gigabitethernet 2/0/3

[DeviceA-gigabitethernet2/0/3] port link-aggregation group 1

[DeviceA-gigabitethernet2/0/3] quit

# Configure Layer 2 aggregate interface 1 as a trunk port and assign it to VLANs 10 and 20.

This configuration automatically propagates to all the member ports in link aggregation group 1.

[DeviceA] interface bridge-aggregation 1

[DeviceA-Bridge-Aggregation1] port link-type trunk

[DeviceA-Bridge-Aggregation1] port trunk permit vlan 10 20

Please wait... Done.

Configuring GigabitEthernet2/0/1... Done.

Configuring GigabitEthernet2/0/2... Done.

Configuring GigabitEthernet2/0/3... Done.

[DeviceA-Bridge-Aggregation1] quit

# Configure to use the source and destination MAC addresses of packets as the global
link-aggregation load sharing criteria.

[DeviceA] link-aggregation load-sharing mode source-mac destination-mac

2) Configure

Device

Configure Device B as you configure Device A.

3) Verify the configurations

# Display the summary information about all aggregation groups on Device A.

[DeviceA] display link-aggregation summary

Aggregation Interface Type:

BAGG -- Bridge-Aggregation, RAGG -- Route-Aggregation

Aggregation Mode: S -- Static, D -- Dynamic

Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing

Actor System ID: 0x8000, 000f-e2ff-0001

AGG AGG Partner ID Select Unselect Share

Interface Mode Ports Ports Type

This manual is related to the following products: