H3C Technologies H3C S7500E Series Switches - Manual (Page 217)

15-9
To do… Use the command… Remarks
Assign the current access port(s)
to a VLAN
port access vlan vlan-id
Optional
By default, all access ports belong
to VLAN 1.
Before assigning an access port to a VLAN, create the VLAN first.
After you configure a command on a Layer 2 aggregate interface, the system starts applying the
configuration to the aggregate interface and its aggregation member ports. If the system fails to do
that on the aggregate interface, it stops applying the configuration to the aggregation member
ports. If it fails to do that on an aggregation member port, it simply skips the port and moves to the
next port.
Assigning a Trunk Port to a VLAN
A trunk port can carry multiple VLANs. You can assign it to a VLAN in interface view (including
Ethernet interface view, Layer 2 aggregate interface view) or port group view.
Follow these steps to assign a trunk port to one or multiple VLANs:
To do… Use the command… Remarks
Enter system view system-view —
Enter Ethernet
interface view
interface interface-type
interface-number
Enter Layer 2
aggregate
interface view
interface bridge-aggregation
interface-number
Enter interface
view (including
Ethernet
interface view,
Layer 2
aggregate
interface view)
or port group
view
Enter port
group view
port-group manual
port-group-name
Required
Use either command.
In Ethernet interface view, the
subsequent configurations apply
to the current port.
In port group view, the
subsequent configurations apply
to all ports in the port group.
In Layer 2 aggregate interface
view, the subsequent
configurations apply to the Layer
2 aggregate interface and all its
member ports.
Configure the link type of the port
or ports as trunk
port link-type trunk Required