H3C Technologies H3C S7500E Series Switches - Manual (Page 134)

11-10
Removing an aggregate interface also removes the corresponding aggregation group. At the same
time, all the member ports of the aggregation group, if any, leave the aggregation group.
Configuring a Static Aggregation Group
To guarantee a successful static aggregation, ensure that the ports at both ends of each link are in the
same aggregation state.
Follow these steps to configure a static aggregation group:
To do... Use the command... Remarks
Enter system view system-view —
Create a Layer 2 aggregate
interface and enter the Layer 2
aggregate interface view
interface bridge-aggregation
interface-number
Required
When you create a Layer 2
aggregate interface, the system
automatically creates a Layer 2
static aggregation group
numbered the same.
Exit to system view quit —
Enter Layer 2 Ethernet interface
view
interface interface-type
interface-number
Assign the Ethernet interface to
the aggregation group
port link-aggregation group
number
Required
Repeat these two steps to assign
multiple Layer 2 Ethernet
interfaces to the aggregation
group.
Configuring a Dynamic Aggregation Group
To guarantee a successful dynamic aggregation, ensure that the peer ports of the ports aggregated at
one end are also aggregated. The two ends can automatically negotiate the aggregation state of each
member port.