H3C Technologies H3C S7500E Series Switches - Manual (Page 216)

15-8
1) In VLAN view
Follow these steps to assign one or multiple access ports to a VLAN in VLAN view:
To do… Use the command… Remarks
Enter system view system-view —
Enter VLAN view vlan vlan-id
Required
If the specified VLAN does not exist, this
command creates the VLAN first.
Assign one or a group of access
ports to the current VLAN
port interface-list
Required
By default, all ports belong to VLAN 1.
In VLAN view, you only assign the access ports to the current VLAN.
2) In interface or port group view
Follow these steps to assign an access port (in interface view) or multiple access ports (in port group
view) to a VLAN:
To do… Use the command… Remarks
Enter system view system-view —
Enter Ethernet
interface view
interface interface-type
interface-number
Enter Layer 2
aggregate
interface view
interface bridge-aggregation
interface-number
Enter
interface view
(including
Ethernet
interface view,
Layer 2
aggregate
interface view)
or port group
view
Enter port group
view
port-group manual
port-group-name
Required
Use either command.
In Ethernet interface view, the
subsequent configurations
apply to the current port.
In port group view, the
subsequent configurations
apply to all ports in the port
group.
In Layer 2 aggregate interface
view, the subsequent
configurations apply to the
Layer 2 aggregate interface
and all its member ports.
Configure the link type of the port
or ports as access
port link-type access
Optional
The link type of a port is access by
default.