Measurement Computing Analyzer488 User Manual
Analyzer488
Table of contents
Document Outline
- Analyzer488
- Warranty
- Warnings, Cautions, Notes, and Tips
- Table of Contents
- 1-Introduction
- 2-Getting Started
- 3-Front Panel Operation
- 3.1 Introduction
- 3.2 Description
- 3.3 Setup
- 3.4 Configuration
- 3.5 Display Panel
- 3.6 Keyboard
- 3.7 Using the Analyzer488 on the IEEE488 bus
- 3.7.1 Controlling Bus Management and Bus Data Lines
- 3.7.2 Viewing Bus Events
- 3.7.3 Recording Bus Events
- 3.7.4 Viewing Recorded Bus Events
- 3.7.5 Using Triggers
- 3.7.6 Viewing the Triggered Bus Events
- 3.7.7 Using Relative Addressing
- 3.7.8 Reviewing Recording Status
- 3.7.9 Searching Record Memory
- 3.7.10 Printing Record Memory
- 3.7.11 Using Low-Level Controller Commands
- 3.8 Key Descriptions
- 4-Serial Controller
- 4.1 Introduction
- 4.2 Description
- 4.3 Serial Interface
- 4.4 Configuration
- 4.5 Using the Analyzer488 with a Personal Computer
- 4.6 Using the Analyzer488 with a Terminal
- 4.7 Serial Controller Commands
- 4.8 Bus State Format
- 4.9 Record Memory Format
- 4.10 Memory Usage
- 4.11 Command Descriptions
- 4.12 Command Descriptions
- 5-Analyst488 Software
- 6-Instrument Simulator
- Appendix A - Front Panel Keys
- Appendix B - Serial Controller Commands
- Appendix C - Instrument Simulator Commands
- Appendix D - Analyst488 Software Menus
- Appendix E - Analyzer488 Error Messages
- Appendix F - Sample BASIC Program
- Appendix G - IEEE 488 Primer
- Appendix H - Character Codes And IEEE Multiline Messages