Measurement Computing Analyzer488 - Manual (Page 57)

Section 3 Front Panel Operation
3.11
3.7.2 Viewing Bus Events
Press [LISTEN] The LISTEN LED will light
to set Listen state
Press [SLOW] The SLOW LED will light.
to set slow handshaking
(Note that slow handshaking speed is set to 3
bytes/sec at the factory. It can be changed using
[RATE]
.)
Enter the following commands to the keyboard controller:
CMD> timeout 0
CMD> term out cr
CMD> output 00;test
SRQ IFC
REN ATN
EOI LOCATION MESSAGE
The display will show:
BUS TAG21 55
¼ ¼
BUS UNL 3F
¼ ¼
BUS LAG00 20
¼ ¼
BUS 't' 74
¼
BUS 'e' 65
¼
BUS 's' 73
¼
BUS 't' 74
¼
BUS CR 0D
¼ ¼
BUS ACG13 0D
¼ ¼
Bus events are displayed as they happen; Eight events occurred
on the bus. The ninth display shows that the controller asserted
Attention after the "test" message. ACG13 is the bus message for the
multiline command: &h0D (ASCII CR).