Measurement Computing Analyzer488 - Manual (Page 257)

Appendix B Serial Controller Command Summary
B.1
PPOLL CONFIG PPOLL CONFIG addr;response
Set the Parallel Poll response of a bus device.
PPOLL DISABLE PPOLL DISABLE addr[,addr ...]
Disable a bus device from responding to parallel polls.
PPOLL UNCONFIG PPOLL UNCONFIG
Prevent all bus devices from responding to a Parallel Poll.
PRINT ?[[location]TO[location]|[location]LENGTH
[
count]|BUS]
Returns bus data or record memory data.
READ READ
Accept data from the bus while in low-level mode.
RECORD RECORD{[?]|[ON|OFF]}
Start or stop recording bus events.
RELATIVE RELATIVE{[?]|[ON|OFF]}
Toggles Relative Addressing Format.
REMOTE REMOTE[addr[,addr ...]]
Assert Remote Enable line or address devices to listen.
RESET RESET
Analyzer488 warm start.
RESUME RESUME
Un-assert Attention (ATN) line.
SEND SEND[;]sub-command[sub-command ...]
Send low level sequences in High Level Controller Mode.
SET RELATIVE SET RELATIVE{[?]|[location]}
Specify record memory reference pointer.
SET TRIGGER SET TRIGGER{[?]|ON|OFF][MATCH[state]
[
line][byte]][# OF MATCHES[match count]]
[ TRIG DELAY[delay]][POST COUNT[post count]]
[ WHEN COMPLETE[STEP|STOP]]}
Configure triggering parameters.